@rogerknoge
Active 4 maanden, 2 weken geleden-
RogerKnoge reageerde in het onderwerp Extra ports for transfer duct. in het forum General questions 4 maanden, 2 weken geleden
It’s an old timer cylinder with a new timer 10mm crank.
Dr50 piston, speed engine case portmatched to this cylinder.
Will use a 13mm carb and a gianelli fire (or power, havent decided yet)I’ll start with a 64 jet and go from there.
Do you know if there is any “real” 38.4 heads with centered sparkplug? All i can find is theese stupid polini…[Lees meer]
-
RogerKnoge reageerde in het onderwerp Extra ports for transfer duct. in het forum General questions 4 maanden, 2 weken geleden
Thank you for the replies!
I decided not to grind extra ports for the transfers.
This is how it turned out in the end. Hopefully it will rip but I have my doubts 😕 -
RogerKnoge reageerde in het onderwerp Extra ports for transfer duct. in het forum General questions 4 maanden, 2 weken geleden
-
zevenenergie wrote:
Hi welcome on the forum RodgerKnoger. Those holes should match holes in the piston. Your piston probably doesn’t have those holes and isn’t designed to have them. You’d weaken the piston. The theory behind those holes is that the pressure in the piston is higher than in the crankcase. That,s because when the piston moves…
-
-
RogerKnoge heeft het onderwerp Extra ports for transfer duct. aangemaakt in het forum General questions 4 maanden, 2 weken geleden
Hi!
I’m currently working on a friends engine.
He want a fast 50cc on a polini speed engine case and I’m almost done with the cylinder (standard 38.4) but I’m not sure if I should mill out extra holes for the transfers (see picture)Â
I have already filed the skirt shorter and thinner at the transfers but do I gain anything from making extra…[Lees meer]
-
RogerKnoge is geregistreerd lid geworden 1 jaar, 7 maanden geleden
