Lath copper-copper mesh? Where does one source such thing? Or are you saying liquid gasket and paper might do? What is an acceptable sealant? Hylomar based something? Every forum seem to favor something different…

Crankshaft moves good when rotating in the crankcase only (two new bearings and a lubricated seal resisting)
Force required to get the cylinder skirt in. This is when the cylinder does not move properly when it hits the pots-definitely more resistance-makes absolute sense, what you are saying. I should spilt the case, shaft out and open up the…[Lees meer]

zevenenergie wrote:
up

DR43mm seems to be out of stock everywhere! 🙂 Must be really good

Thanks for chiming in and confirming 13/13 is a solid choice. From the looks of it, I will need few carburetors…and DR43mm kits when they become available. The question now is how to proceed with the motors–the 12mm pin one is a risk considering the poor…[Lees meer]

sx3-swe wrote:
Hi Peter, I guess you’ve imported thoose mix-ciaos to Sweden? Since they weren’t sold on our market. No license plate required as you state, but you still need the “typintyg” for the mopeds to be road legal. Not saying that I following that very strictly at all, but tecnically it’s in the books. 🙂 Thoose who attended VCNL meet 201…

[Lees meer]

Thank you for the warm welcome and Zevenenergie, what a wonderful creature that is 😛 !
Here is the situation as of now:
Black Ciao:

• Looks like a Mix, motor is from a Mix, frame carries C2400 plate, oil pump missing and tank isolated.
• No variator
• Electronic ignition
• Scored piston, a LOT less scoring on cylinder but visible, not…

[Lees meer]