Vespa-Ciao.NL
:: Gasket for 2-gear gearbox

Home Forums English General questions Gasket for 2-gear gearbox

12 berichten aan het bekijken - 1 tot 12 (van in totaal 12)
  • Gebruiker
    <i class="fa fa-comments-o" aria-hidden="true" style="font-size: 20px;"></i>
  • #144328

    Piet30
    Topic starter
    Berichten: 1082

      Hi, is there an expert who knows where to get the gear box gasket for a Bravo 2-gear ? 😐

      For this one

      #145514

      Lennaert
      Sleutelbeheerder
      Berichten: 4043
        #144659

        Piet30
        Topic starter
        Berichten: 1082

          hey, cool, but it shows 25,- delivery cost :((

          #144975

          wim v8
          Bijdrager
          Berichten: 294

            You can cut it from a big leave of gasketpaper.

            Gr. Wim.

            #145487

            Piet30
            Topic starter
            Berichten: 1082

              yes, that is finally what I need to do.

              Can you recommend a gasket paper with good function for gearbox oil?

              #145461

              wim v8
              Bijdrager
              Berichten: 294

                No, you can better ask that question at the shop were you buy. Only take the same thickness.

                #145452

                Jasper-Grillo
                Bijdrager
                Berichten: 107

                  you can use liquid gasket?

                  #144846

                  Piet30
                  Topic starter
                  Berichten: 1082

                    mmh, then I do not have the thickness of a paper gasket (maybe 1mm) between housing and cover.
                    The cover then could be too tight on the housing and squeeze the gear wheels in the bearings.

                    #144946

                    Jasper-Grillo
                    Bijdrager
                    Berichten: 107

                      you can put some on the old gasket. Then you have a oil-tight seal with the original thickness.

                      #144947

                      Martino
                      Moderator
                      Berichten: 7384

                        Originally there was only a thin gasket beeing used. 0,3 max 0,4mm.

                        I’ve just found out, i can lasercut gaskets at my workplace. I will try to extract a complete functional gasket of one of my 2-speeds. So i can duplicate these gaskets in any desired thickness, but the 1mm seems way to thick in my opinion.

                        #144651

                        Piet30
                        Topic starter
                        Berichten: 1082

                          🙂 was a rough estimation. I measured the thickness of the old gasket, it is 0,3mm.

                          Laser cutted gasket sound great. :thumb

                          Jasper, yes that could work. But when I opened the gear box the old gasket was sometimes glueing on the housing and sometimes on the cover. So the old gasket is splitted in some areas and cracked many times. No chance to use it again.

                          #144650

                          Crullie
                          Donateur
                          Berichten: 2279

                            120grams a square meter, Xerox A4 printer paper will do just fine :thumb

                            Its al about the weight of the paper what the density determed and offcoure a flat surface.

                            TICKLING BARN
                          12 berichten aan het bekijken - 1 tot 12 (van in totaal 12)
                          • Je moet ingelogd zijn om een reactie op dit onderwerp te kunnen geven.